Monday, October 26, 2020
Home IPhone & IPad Cleaning a Dirty iPhone: A Step-by-Step Guide

Cleaning a Dirty iPhone: A Step-by-Step Guide

When iPhone travels with you, it will likely collect dirt along the way. Wiping the screen with your sleeve is just so much. Your phone can be dangerous to health and needs to be cleaned.

Quick links

However, you need to be careful when cleaning iPhone. You can’t just use something you find in the closet, otherwise you could damage it. Next, we’ll walk you through the instructions on how to clean a dirty iPhone.

Are you cleaning your iPhone? Do this first

Before you rush to the next steps, consider for a moment how to clean your iPhone. Make sure you have the following ready to use:

  • Table or desk
  • Small towel
  • A bowl of warm soapy water
  • A bowl of cold tap water
  • Isopropyl alcohol
  • Lint-free fabrics (usually with glasses)
  • SIM card slot key, paper clip, or similar
  • Soft toothbrush
  • Toothpick
  • cotton Exchange
  • Handheld vacuum cleaner
  • Plenty of time

In the final step: it is important that you set aside enough time to clean your phone. You need to make the device, grab the cleaning tools you need, and be patient. Don’t rush through this.

Follow the instructions below to clean iPhone.

1. Clean the iPhone case

Clean your iPhone case

You can clean the case separately as it is much more resistant to damage than your iPhone. Replacing the case is also relatively inexpensive if something happens to it.

Remove the housing, clean according to the manufacturer’s cleaning instructions, if any. If not, remove dirt and grime from the case with warm soapy water. Pay attention to the various apertures, including the charging ports, mute lever, volume controls, and the aperture of the camera lens.

Let your iPhone case dry. Then turn your attention to the phone itself.

2. Clean the iPhone screen

Clean the iPhone screen

Be especially careful with the monitor, which is the most sensitive part of the device. Apple is applying an oleophobic coating to the iPhone screen to help fight finger grease and oil. This also applies to the back of iPhone 8 series devices.

To preserve the oleophobic coating, you should only use water to clean the iPhone screen.

Do not use abrasive cleaners, glass cleaners, surface sprays, rub alcohol, or anything else that promises to cut through the grease. These substances will damage the screen coating.

Take a soft, lint-free fabric and moisten it with tap water. You should already have lint-free fabric, but if not, you can buy them cheap online. They are the same ones you use to clean glasses, camera lenses, and other coated scratch-prone surfaces.



Non-woven fabrics


Non-woven fabrics

Buy now from Amazon
$ 8.49

During cleaning, wipe in the same direction by pushing grease and dirt off the screen. This can take several towels and a few more drops of tap water. You can add glass screen protector






6 tips for tempered glass cover for your phone
Are you looking for a tempered glass protector? Here are six tips for buying a tempered glass screen protector.
Read more

with a fresh oleophobic coating if the situation is really bad.

3. How to clean the iPhone charging port

Learn how to clean your iPhone's charging port

If yours The iPhone doesn’t charge as well as it used to






5 Reasons Why Your Phone Charges Slowly
Wondering why your phone isn’t charging as fast as it used to? Here are a few possible reasons to explain why.
Read more

, the charging port may be at fault. Pocket lint, fluff, pieces of paper, and other debris can prevent internal pins from joining the charger.

Apple does not recommend using compressed air to clean any part of iPhone, and the charging port is no exception. One of the first parts of the device that Apple Genius checks is the charging port, so clean it gently.

One of the best tools clean the iPhone’s charging port






How to Clean iPhone Charging Port |
If iPhone doesn’t charge, the Lightning port is probably dirty. This makes it easy to clean the charging port on iPhone.
Read more

is the SIM card slot key that came with your device. If you can’t find it, a mounting pin or similar thin object with a good point is a smart option. Put the pin in the hole and scratch what you can. Wipe what you find and repeat until it is clean.

Apple does this with amazingly great power in the Genius Bar, but we recommend that it’s not too hard. Shine a light in the harbor to check for remnants of dirt.

4. Clean the flash cable contacts

Improve connections with a clean flash unit

Another reason iPhone may not charge properly is the status of the Lightning cable. In particular, the contacts can be pressed against the stuff going to the charging port. This will cause dirt to accumulate on the cable connectors, which may prevent proper charging.

Disconnect the Lightning cable from both ends before cleaning. Wipe the contacts clean with a damp cloth until you see them glow – they should be gold. Allow the connector to dry before using it again. This is also a good time check the cable for damage or wear






When to throw cable and phone chargers
Let’s get caught up in the chase now – with a benevolent plot, we really want you to read this article for just one reason: to throw away shredded, damaged chargers NOW.
Read more

.

5. How to clean the iPhone speaker and microphone holes

Clean the iPhone microphone

The speaker and microphone are on the bottom of iPhone, on either side of the charging port. This is one of the most difficult areas to clean and most likely a soiled area.

Do not use compressed air, as pressure can damage your iPhone or compromise water resistance. Instead, take a fine, very soft toothbrush and rub the area lightly to loosen any dirt. Be careful not to use too much force.

Some online users recommend using fine-grained toothpicks when a toothbrush is not enough. If you do, be careful not to push too hard and cause injury. Cleaning this area can improve the sound quality and make your voice clearer during calls.

Learn more about voice instructions fix iPhone speaker when it doesn’t work






iPhone speaker not working? Here’s how to fix it
Does the iPhone speaker not work? This will allow you to repair the iPhone speaker and make the sound work again.
Read more

.

6. Clean the mute switch

Get the strap off the mute switch

Each iPhone has a mute switch on the left side of the device. Certain cases can actually aggravate the formation of debris, making the switch difficult to clean. Eventually, it can be difficult to change the switch.

And if you never touch this switch (if, for example, iPhone is always in vibration mode), it’s probably full of dirt.

Take a fine toothpick and scrape off the dirt. Turn the switch a few times to clean both sides.

If this is not enough, a fine cotton needle with isopropyl alcohol should do the trick. It is very important that alcohol does not get on the screen or other sensitive parts of iPhone. This chemical can remove protective coatings, which affects the user experience.

An infectious mute lever can cause Problems controlling iPhone volume






Is iPhone volume not working as it should? try this
Does iPhone volume not work? Here’s how to fix iPhone volume issues and ways to increase iPhone volume even further.
Read more

, so it is worth checking during this process.

7. Clean the home button

If you have an older iPhone, another important area to keep it clean is the Home button. In fact, it’s so important to keep this clean that you should consider carrying a soft, lint-free fabric with you.

The knob should be cleaned frequently, perhaps weekly. Because the button handles the Touch ID with the built-in fingerprint sensor, clean it as regularly as it does on your screen. Even a thin layer of fat can prevent your fingerprints from registering.

8. Clean the iPhone’s sensor system

On newer iPhone models with Face ID (iPhone X and later), the opening at the top of the screen is full of sensors. Their performance deteriorates when there is a layer of grease on the screen.

So if you find that Face ID can’t unlock iPhone, cleaning the sensor system will help. Wipe it with the same cloth you used elsewhere.

9. Remove grease from the iPhone camera lens

Keep your iPhone camera clean

Like the Home button and sensor system, both front and rear cameras are prone to grease buildup.

Learn how to recognize dirty lens cover marks in the viewfinder of your chosen camera application. Search:

  • Light stripes
  • Breakthrough highlights
  • Foggy picture
  • focusing Difficulty

Cleaning takes care of all these problems. Only wipe the glass covering the lens regularly with a soft, damp, lint-free cloth.

One last note about the water resistance of the iPhone

If you have an iPhone 7 or later, the phone is certified waterproof






What makes a device waterproof or waterproof?
A lot of devices are marketed as waterproof, but they can be misleading. Most are really water resistant. What difference? Here is everything you need to know about it.
Read more

. The iPhone 7, 8, X and XR are IP67 rated, which means they can survive being underwater for 30 minutes at a depth of about 3.3 feet. Meanwhile, the iPhone XS and later are proud of their IP68 durability, so they can survive at least twice the depth at the same time.

Apple achieves this rating with a rubber seal that protects the interiors from moisture and dust. Over time, this rubber seal can shrink, especially if your iPhone is physically damaged. A broken screen, notches in the body, or unintentional bending of the pocket (while sitting) can damage the seal.

While this may cause you to clean iPhone with water, do not expose it to anything other than cold tap water. Forget pressurized water, salt water or other liquids. And if you drop iPhone into the sea or pool, rinse it immediately with tap water.

Despite its water resistance, don’t keep iPhones waterproof. Never clean your iPhone just by running it under the tap. Since then, hot water is also a bad idea heat can kill iPhones






iPhone or iPad getting hot? Here’s why and how to fix it
Is the iPhone or iPad too hot? This will let you know when the appliance overheats and how it cools down properly.
Read more

(as well as sudden changes in temperature). Repeated exposure to running water can also accelerate the wear rate of the oleophobic coating.

Congratulations: The iPhone is now clean

Cleaning these steps after iPhone gives you a device that looks and works better. It should be almost as good as new – definitely the best you’ve seen on your iPhone after you’ve removed it.

Be sure to keep your iPhone clean by following these steps every couple of months. And don’t forget to carry a lint-free cloth to keep the device from grease.

After you have physically cleaned your iPhone, you should also clean the software side free up iOS storage






iPhone storage full? How to create free space for iOS
The “iPhone Storage Full” message is sent to us when we least expect it. Here are ways to free up storage on iPhone.
Read more

.

Patriotic Hackershttps://patriotichackers.com
Patriotichackers.com is an online tech and life hacks website. You can get here all kinds of content on Simplified Technology and Crafts. So you can catch us on Social Media Platforms to stay updated with us.

LEAVE A REPLY

Please enter your comment!
Please enter your name here

Most Popular

Recent Comments